Scheppach HS105 Traduction Des Instructions D'origine page 30

1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no lia-
bility for damage to the device or caused by the device
arising from:
• Improper handling,
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
13 / VDE0113 not being observed.
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
This operating manual should help you familiarise
yourself with your power tool and teach you how to use
it for its intended purpose.
The operating manual include important instructions
for the safe, proper and economic operation of the
power tool, for avoiding danger, for minimising repair
costs and downtimes and for increasing the reliability
and extending the service life of the power tool.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the power tool in your country.
Keep the operating manual package with the power
tool at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and careful-
ly observed by all operating personnel before starting
the work. The power tool may only be used by per-
sonnel who have been trained to use it and who have
been instructed with respect to the associated haz-
ards. The required minimum age must be observed.
30 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1-4)
1. Saw table
2. Saw blade guard
3. Extraction hose
4. Riving knife
5. Saw blade
6. Table inlay 6.1. Screw for table inlay
7. Parallel stop
8. Hand wheel
9. Adjustment and locking handle
10. Machine stand
11. On, off switch (green "I" button, red "O" button)
12. Guide rail
13. Transverse stop
14. Table width extension
15. Rear guide rail
16. Push stick
17. Legs
18. Cross members
19. Longitudinal members
20. Centre struts, short
21. Centre struts, long
22. Rubber feet
23. Riving knife locking lever
24. Screw
25. Stop rail
26. Sight glass
27. Parallel stop scale
28. Table width extension scale
29. Parallel stop clamping lever
30. Groove
31. Transverse stop clamping handle
32. Transverse stop scale
33. Table width extension clamping lever
34. Wheels
3. Scope of delivery
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
www.scheppach.com