Gewiss JOINON Manuel D'installation Et Usage page 74

Gewiss
# Action to be carried out
7 The car is asking the charging station for energy
8 Recharging session in progress
To end the charging session, take the same RFID card used
to launch the session and swipe it across the scanner again.
9
In this case, the station ends the session by releasing the plug
10 Take the plug out of the socket-outlet on the charging station side
11 If the station detects no errors, it will return to standby
10.3. Stand-Alone with Restart and RFID card reader
See section 10.2
10.4. Via mobile app and OCPP cloud platform
In this mode, the charging station is connected to a control platform via the OCPP protocol. The OCPP protocol allows the station
to connect to any platform which uses that protocol.
To take advantage of this mode, a specific parameter configuration is needed in order to create correct station-platform communication.
The use of connected solutions allows access to a series of advanced options that give both the end user and the owner better access
to the service.
The end user can use the JOINON app or a similar expedient to find the nearest recharging station and access the service by following
the instructions given.
The station owner can monitor the status of the station and the consumption level from remote and in real time.
74
in the type 2 socket-outlet
RGB LED status Words on the display
RECHARGE IN PROGRESS
Fixed blue
RECHARGE IN PROGRESS
RECHARGE IN PROGRESS
Fixed blue
RECHARGE IN PROGRESS
From fixed or flashing blue
to flashing green
From flashing green
to fixed green
Fixed green
7.55.4.515.2 - Installation and Operation Manual
Charging process
Ts=0000 Tc=0000
kW=0000 kWh=0000
Ts=0000 Tc=0000
kW=0000 kWh=0000
CARD ENABLED
*PLEASE WAIT*
RECHARGE TERMINATED
REMOVE THE CABLE
SESSION SUMMARY
Ts=0000 Tc=0000
SESSION SUMMARY
kW=0000 kWh=0000
SWIPE THE CARD
TO RECHARGE