Gewiss JOINON Manuel D'installation Et Usage page 52

Gewiss
3. Safety function
This section describes the safety warnings and the personal protective equipment.
3.1. Safety conditions
General warnings
The operations described in this manual may only be performed by duly qualified personnel.
When this manual refers to qualified personnel, this means personnel complying with all the standards, directives and
laws concerning safety, as applicable to the installation and operation of this device.
The selection of qualified personnel is always the responsibility of the company that carries out the work, which is
the only party that can decide whether a worker is capable of doing a certain job, thereby ensuring their safety and
respecting the applicable law with regards safety in the workplace.
These companies must provide suitable training regarding the electrical devices for their personnel, and make sure they
become familiar with the content of this manual.
It is mandatory to comply with the applicable safety laws relating to electrical work. There is the risk of possible
electrical shock.
Risk of electric shock.
Compliance with the safety instructions provided in this manual or by the legislation indicated does not imply exemption
from compliance with other specific standards regarding the installation, location, country or other circumstances that
concern the device.
The opening of the casing does not imply the absence of voltage inside.
Interventions must only be carried out once the voltage supply to the system has been cut off using a device that can
guarantee insulation.
It may only be opened by qualified personnel, following the instructions given in this manual.
It is mandatory to read and understand all parts of this manual before starting to handle, install or use the unit.
Gewiss disclaims all liability for any damage caused by inappropriate use of the charging stations. Any operation carried
out on these charging stations that involves a change to the original electrical settings must be authorised by Gewiss
beforehand. All such proposals must be examined and approved by Gewiss.
Before carrying out any interventions, cut off the voltage supply to the system using a device that can guarantee
insulation.
As the minimum safety measure for this operation, observe the following rules:
1. Cut off the voltage supply.
2. Prevent the reactivation of the power supply.
3. Check there is no voltage.
4. Protect yourself against energised elements nearby, and place safety signals to mark off the work area
if necessary.
Until these steps have been applied, the product must be considered powered; no interventions are therefore authorised.
Potential hazards for people
In order to protect your own safety, observe the following warnings.
52 7.55.4.515.2 - Installation and Operation Manual
Safety function