Publicité
Problem
Engine will not start
the engine rpm is increased.
produce impact.
Maintenance
The Altrad Belle RTX
maintenance listed in this section is carried out.
It is recommended that an approved Altrad Belle dealer carries out all major maintenance and repairs. Always use genuine Altrad Belle
HT lead from the sparkplug.
Always set the RTX
Servicing the Engine
Yanmar L48 Engine Priming
below instructions.
CAUTION
the tank.
2. Slide the Engine Speed Control Lever to the RUN position.
Injector Pipe Nut (Item 2).
4. Slacken the Injector Pump Nozzle (Item 3) by 2 full revolutions
NOTE:- DO NOT remove the Injector Pump Nozzle.
5. Hold the Injector Pipe away from the Injector Pump Nozzle and wait until
Diesel is running freely without any air bubbles.
6. Re-tighten the Injector Pump Nozzle to a setting of 12Nm.
section of this manual.
Trouble Shooting Guide
Cause
No fuel
Fuel Tap has been closed
Engine not primed. (GX100 Only)
Engine not primed. (Diesel Only)
Spark Plug contaminated or damaged.
(Petrol Only)
Faulty Carburettor. (Petrol Only)
See Above
Main jet of the Carburettor clogged with
dirt. (GX120 Only)
Spark plug cap is loose. (Petrol Only)
Lack of engine power
Clutch is slipping
Crank mechanism is damaged
Service & Maintenance
(Item 1) by loosening the
46
Remedy
Fill Fuel Tank
Open fuel tap.
Push the Carburettor Primer Bulb 4 times and
See the Service & Maintenance section of this
Manual.
Replace spark plug.
Service the Carburettor
See Above
Take out the main jet of the Carburettor and
clean with Compressed air.
Clean the element.
See above.
drum with proper solvent. Replace clutch
shoe if necessary.
Contact Dealer.
1
2
3
Publicité
