Inspection And Maintenance By User - Stihl FS 94 R Notice D'emploi

Adjusting Nylon Line
STIHL SuperCut
Fresh line is advanced automatically if
the remaining line is at least 6 cm
(2 1/2 in) long. The blade on the
deflector trims overlong lines to the
correct length.
STIHL AutoCut
With the engine running, hold the
N
rotating mowing head above the
grass surface.
Tap it on the ground once – fresh
N
line is advanced and the blade on
the deflector trims it to the right
length.
Fresh line is advanced every time the
mowing head is tapped on the ground.
For this reason observe the mowing
head's cutting performance during
operation. If the mowing head is tapped
on the ground too often, the line limiter
blade will unnecessarily cut off unused
lengths of nylon line.
Line feed operates only if both lines are
still at least 2.5 cm (1 in) long.
Replacing Nylon Line
STIHL PolyCut
Precut lengths of nylon line can be fitted
to the PolyCut in place of the cutting
blades.
FS 94 R
STIHL DuroCut, STIHL PolyCut
WARNING
To reduce the risk of injury, always shut
off the engine before refilling the mowing
head.
Fit nylon line in the mowing head as
N
described in the instructions
supplied.
Replacing Cutting Blades
STIHL PolyCut
Always check the mowing head for signs
of wear before installing new cutting
blades.
WARNING
If there are signs of serious wear,
replace the complete mowing head.
The thermoplastic cutting blades are
referred to as "blades" in the following.
The mowing head is supplied with
illustrated instructions for replacing the
blades. Keep the instructions for the
mowing head in a safe place.
WARNING
To reduce the risk of injury, always shut
off the engine before installing the
blades.
Remove the mowing head.
N
Replace blades as shown in the
N
illustrated instructions.
Mount the mowing head on the
N
machine.
Inspection and Maintenance
by User
Throttle Cable
Checking adjustment of throttle cable
Error: Engine speed increases when
only the throttle trigger is depressed.
Start the engine.
N
Depress the throttle trigger (1) – do
N
not press down the throttle trigger
lockout (2).
If the engine speed increases or if the
cutting attachment rotates, the throttle
cable has to be adjusted.
Shut off the engine.
N
Have throttle cable adjusted by your
N
dealer. STIHL recommends an
authorized STIHL servicing dealer.
Spark arresting screen in muffler
WARNING
To reduce the risk of fire caused by hot
particles escaping from the machine,
never operate the machine without a
spark arresting screen, or with the spark
English
2
1
29