Finalizing The Installation - Dometic 4000 Série Guide D'utilisation

Toilets
24
4-Wire Control
Module Cable
➤ Route the wiring and discharge plumbing
through the holes .
➤ Provide extra discharge hose length to
connect to the toilet . Refer to
"4 .2 Minimum system requirements" on
page 5 .
➤ Proceed to "6 .5 Finalizing the installation"
on page 14 .
6.4 Toilet system with "full tank" shut-down relay and tank monitor system
I
All installations can be set up to include "full tank" shut-down relay and tank monitor
system options . Consult the wiring diagrams included with the product for further
details . Wiring associated with these options needs to be done prior to the next step .
➤ Route the input power wires from the "full tank" shut-down relay to the flush-switch panel .
➤ Proceed to "6 .5 Finalizing the installation" on page 14 .
6.5

Finalizing the installation

25
Toilet
Water Supply
Connection
4500, 4600, 4700, and 4800 models
➤ Set the toilet in front of the discharge adapter .
➤ Connect the toilet water line to the water supply line .
➤ Make the final wiring connection:
➤ 4500, 4600, and 4800 models: Connect the 4-pin connector to the control module
cable .
➤ 4700 models: Connect the 3-pin flush handle connector to the 3-pin wire from the
control module .
EN
26
4-Wire
Control
Module
Cable
Toilet
Discharge
Assembly
Water Supply
Connection
Discharge
Assembly
4600, 4800
models
(Rear View)
4-Wire Control
Module Cable
4700 models
(Rear View)
14