Dometic 4000 Série Guide D'utilisation page 11

15
Vacuum Hose
Models xx06 and xx09 floor flange only:
➤ Mark the floor through the mounting
holes on the floor flange .
➤ Remove the flange and drill the pilot holes
using an 11/64" drill bit .
➤ Route the vacuum hose from the vacuum
generator or vacuum tank up through the
discharge flange hole .
➤ Lubricate the inside of the hose with liquid
dish soap and install the hose onto the
adapter .
➤ Secure the connection using two
stainless-steal hose clamps .
11
Floor Flange
16
Discharge Adapter
Model xx48 discharge adapter:
➤ Mark the floor through the mounting
holes on the discharge adapter .
➤ Remove the discharge adapter and drill
the pilot holes using an 11/64" drill bit .
➤ Mount the discharge adapter to the floor
using the four #14x1"pan-head
phillips-head screws and washers
provided .
➤ Connect the discharge plumbing to the
vacuum tank or vacuum generator . Use a
1-1/2" OdorSafe Plus flexible sanitation
hose or 1-1/2" PVC schedule 40 pipe .
➤ If using a flexible hose, lubricate the inside
of the hose with liquid dish soap and
attach the hose to the adapter .
➤ Secure the connection using two
stainless-steel hose clamps .
Toilets
Elbow Fitting
EN