Dometic 4000 Série Guide D'utilisation page 12

Toilets
Hex Nut
17
Flange
Gasket
#12x1-1/2"
Flat Head Screw
Models xx06 and xx09 floor flange:
➤ Insert four T-bolts into the discharge
flange from the underside .
➤ Insert the discharge flange and connected
hose or pipe into the discharge hole and
secure it to the floor using the eight #12x1-
1/2" flat-head screws provided .
➤ Install the flange gasket over the T-bolts .
➤ Install the floor flange adapter with the
words THIS SIDE UP facing up . Tighten
the adapter to the floor in a criss-cross
pattern, using four flat washers and hex
nuts .
19
Flush-Switch
Panel
➤ Route the flush-switch Ethernet cable
from the Ethernet connection on the toilet
control board through the access hole on
the wall .
➤ Secure the Ethernet cable to the flush-
switch panel .
➤ Snap the flush-switch panel cover onto the
panel bracket .
➤ Proceed to "6 .5 Finalizing the installation"
on page 14 .
EN
18
Washer
Cables
Floor Flange
Adapter
T-bolt
Floor Flange
➤ Route the DC power wiring and 1/2"
diameter water line through the drilled
holes . A shut-off valve should be placed in
the water line to the toilet for maintenance
or repair .
I
➤ Provide extra discharge hose length for
connection to the toilet . Refer to
"4 .2 Minimum system requirements" on
page 5 .
Ethernet
Cable
Water Line
Refer to "5 .2 Wiring/electronic
control module connections" on
page 8, and to the wiring
diagram provided with the toilet
model's parts list . Connector
configuration varies by model .
12