Planika FLA3 Notice De Montage page 16

SETTING
Device IP View the IP address to configure wireless connection (only if a Wi-Fi network is configured).
WIFI CONFIG Wireless control configuration (see the next page).
MTZ mode External temperature module configuration (read the manual included with the module).
Control panel lock. Enable by pressing
Lock the device
for 5 seconds.
Child lock – flame ignition is initiated by pressing START/STOP for 3 seconds. Choose
Child lock
ON/OFF to enable/disable the function.
Set time
Set the hour by pressing
Programming a new remote or connecting one remote with multiple devices. Press
Remote Control
the configuration. Press and hold START, STOP,
PROGRAMMING FINISHED informs that the configuration has been successfully completed.
Display off If inactive for 1 minute, the display will turn off. Choose ON/OFF to enable or disable the option.
Faster flame ignition (enabled by default). The power consumption is 100W higher when
Fast start
the device is ready for flame ignition. Choose OFF to disable.
Serial number View the device serial number.
Software View the software version.
History View 40 recent messages.
1. To start the configuration, select Wi-Fi CONFIG in the menu. Time to finish the configuration is 5 minutes.
2. Enable Wi-Fi connection in your mobile device and connect to planika123 network (if the network is not visible on the list,
disconnect the power supply from the device for 10 seconds and start the configuration again).
3. Start the application on your mobile device. The fireplace will be appear in the Manager window.
4. Connect to the fireplace and go to SETTINGS. Choose the connection mode (MODE) and security protocol (SECURITY).
Enter the network name (SSID_NAME) and password (PASSWORD).
5. If static IP is required, enter IP ADDRESS, NETMASK and GATEWAY. For dynamic IP enable DHCP. Accept the settings
by pressing submit.
MODE
Blocks wireless control
via Wi-Fi.
SECURITY
SSID_NAME
PASSWORD
6. Connect to the selected/created network in the Wi-Fi menu in your mobile device.
7. The application will automatically search for the fireplace.
ERRORS
The errors are accompanied by a sound signal. Press START/STOP to mute or turn the device OFF by pressing
ERROR
TEMPERATURE TOO HIGH
+
, next press
WIRELESS CONTROL CONFIGURATION
OFF
Connection with via your local network and
Choose the security protocol used in your
--
(usually WPA/WPA2).
-- Enter the name of your local network.
-- Enter your local network password.
(contact the Service Department if the solution does not eliminate the error)
DESCRIPTION
–
in the menu. To disable, press and hold START/STOP
–
and set minutes. Accept with
–
+
,
STA
a router
local network
SOLUTION
Wait for READY.
16
–
.
for 1 second, respectively. Message
AP
Direct connection between the device
and your mobile device (outside your
local network)
Choose security protocol WPA
(recommended) or WEP.
Create a network name.
Create a network password
(min. 8 characters).
–
to start
.