Planika FLA3 Notice De Montage page 15

When the flame is ignited (WORKING), press
height is 4.
ATTENTION! In case the device temperature is too high, the flame will be automatically lowered and the height
regulation blocked. If the temperature keeps increasing, the flame will be extinguished (COOLING THE DEVICE,
TEMPERATURE TOO HIGH).
To extinguish the flame:
- press or
- press STOP In this case, an additional system of fans will be enabled to cool the device faster.
.
Message COOLING THE DEVICE indicates that the device is being cooled. You can ignite the flame again when
the device is cooled – message READY.
To turn the device OFF, press
The device will be turned OFF automatically once any error occurs (see the error table on the next page).
The SLEEP function extinguishes the flame after a set period of time (max. 3 hours).
When the flame is ignited (WORKING), press and hold
which the flame will be extinguished and accept with
indicating the time remaining to flame extinguishing.
MENU
The menu is available when messages READY or NO FUEL are displayed. To enter the menu, press and hold
seconds. Scroll through the settings with
press .
FLAME HEIGHT REGULATION
–
+
or to make the flame higher or lower in 6 levels. The default flame
FLAME EXTINGUISHING
TURNING THE DEVICE OFF
.
SLEEP FUNCTION
+
–
. A timer will appear in the right upper corner of the display,
+
and accept by pressing
15
–
and for 10 seconds. Then, press
–
. To quit the menu, wait for couple of seconds or
+
to set the time after
+
for 8