Wolf ICBDF48650G/S/P/LP Guide D'installation page 7

IN S TA L L AT I O N
Preparation
Before moving the range, protect any finished flooring and
secure oven door(s) closed to prevent damage.
To lighten the load or to fit through a door way, the oven
door(s) can be removed. Remove only if necessary. Do not
remove the griddle or any other component. Door removal
should be done only by a certified installer or service
technician.
For removal, a hinge pin will be inserted into the appropriate
hinge shown in the illustrations below. The pin(s) are located
inside the oven door. For single oven ranges, the hinge pin
must be inserted in the right hinge. For double oven ranges,
the pins must be placed in the outer two hinges.
CAUTION
Failure to insert the hinge pin in the appropriate hinge
arm will cause damage to the range.
SPRING HINGES
SPRING HINGE
Single oven ranges
SPRING HINGES
Double oven ranges
SPRING HINGE
OV EN D O O R R EM OVAL
Insert the hinge pin into the appropriate hinge.
1
Remove the lower kickplate assembly to access the
2
lower hinge retainer mounting screws.
Open the oven door and remove both upper and lower
3
hinge retainer mounting screws. The oven gasket may
have to be moved slightly to access the bottom screws.
Move the hinge retainer plate forward slightly. The hinge
4
retainer plate will remain on the door hinge after the
mounting screws have been removed.
Carefully close the oven door to approximately 60°, then
5
lift the door up and out. A slight rocking motion may be
required for removal.
HINGE
UPPER RETAINER
MOUNTING PLATE
SCREW
HINGE
PIN
KICKPLATE
Oven door removal
|
wolfappliance.com 7