Publicité
Les langues disponibles
Les langues disponibles
forward by 2 to 3 mm. Make this checking for each cutter
on the right and left side of the cutter.
It is impossible to obtain a good planing and surfacing re-
sult when this adjustment is not done with precision.
•Screw the fixing screws of the tightening wedge shaped
parts well with a wrench SW 6 at 8,9 Nm.
•Adjust and tighten all cutter blades in the same way.
•After each replacement of the cutter blades perform a test
running and tighten again the fixing screws at 8,9 Nm.
Before starting the cutter block make sure that all instruc-
tions given above have been followed.
While using the machine follow all general security instruc-
tions of this manual.
Grinding of planer knives
Dull planer knives increase the risk of accident. The
operation efficiency is no longer guaranteed.
Regrind the planer knives only up to 16 mm of the height
of the knives. The cutting angle of the knife should have
40 ± 2 grade.
The re-grinding of the planer knives has to be done
by an authorised firm or send the knives back to the
manufacturer.
Scheppach Fabrikation von Holzbearbeitungsmaschinen
GmbH
Günzburger Straße 69
0-89335 Ichenhausen / Germany
Planer blades:
Plana 3.0c
1 Set planer blades 250:
1 Set reversible planer blades 250: 330 Plana 3.0c 703
1 Set knife carriers 250:
Plana 4.0c
1 Set planer blades 310:
1 Set reversible planer blades 310: 330 Plana 4.0c 703
1 Set knife carriers 310:
330 Plana 3.0c 702
330 Plana 3.0c 704
330 Plana 4.0c 702
330 Plana 4.0c 704
english 15
Publicité
