Operating Elements - Monacor International JTS MH-850/1 Mode D'emploi

Wireless dynamic microphone
These instructions are intended for users without
any specific technical knowledge Please read the
instructions carefully prior to operation and keep
them for later reference
3
4
9
CH
8
6
1
5
PUSH
5
2
13
3 4

1 Operating Elements

1.1 Fig. 1: Hand-held microphone
1 Microphone cartridge; to insert batteries, un-
screw the cartridge (figs 2 to 4)
2 Cap for the control part; remove the cap to adjust
the transmission channel (fig 5)
3 LED status indicator: shows
– green as a power indication
– red when the batteries are almost discharged
4 Power switch
1.2 Figs. 2 – 4: Inserting batteries
(microphone cartridge unscrewed)
5 4-pole contact, one each on the microphone
cartridge (fig 2) and on the handle (fig 3);
prior to assembling the microphone cartridge
and the handle, fit the contacts into each other
6 Lock for the battery holder (7);
to unlock the holder, push the lock to the rear
in arrow direction
7 Battery holder for two 1 5 V batteries of size
6
AA (R6)
7
1.3 Fig. 5: Control part
(cap removed)
8 Rotary switch CH to adjust the transmission chan-
nel with the adjusting key supplied
2 Important Notes
The wireless microphone corresponds to all relevant
directives of the EU and is therefore marked with
•
7
The microphone is suitable for indoor use only
Protect it against dripping water and splash
water, high air humidity and heat (admissible
ambient temperature range 0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never use
chemicals or water
•
No guarantee claims for the microphone and
no liability for any resulting personal damage or
material damage will be accepted if the micro-
phone is used for other purposes than originally
intended, if it is not correctly operated or if it is
not repaired in an expert way
If the microphone is to be put out of
operation definitively, take it to a local
recycling plant for a disposal which is not
harmful to the environment