Dimplex BOF4056 Manuel Du Propriétaire page 8

Installation
Figure 2
Cable Plate
feed the supply cable through
the connector and secure.
5. Remove the 3 wires from
within the unit.
6. Connect the black wire (live)
from the unit to the black wire
from power supply.
7. Connect the white wire (neu-
tral) from the unit to the white
wire from power supply.
8. Connect the two green wires
(ground) from the unit to the
green wire from power supply.
9. Place all connectors inside
the unit and secure the cable
clamp to unit. Ensure that the
cable clamp grips only the
jacket of service cable.
! NOTE: Once the unit has been
fully installed there is an access
8
Figure 3
Bottom
Flanges
panel in the water reservoir cavity
where the wiring can be accessed
from the front following installation
(Figure 3).
10. Install the unit into the roughed
in framing.
CAUTION: When inserting
the unit take care not to damage
or pinch any of the power cables
that are concealed in the wall.
WARNING: Ensure the power
wiring is not installed so that it
is pinched or against a sharp
edge and ensure that the pow-
er wiring is stored or secured
to avoid tripping or snagging to
reduce the risk of fire, electric
shock or injury to persons.
11. Secure the unit to the framing
through the bottom flanges
with 6 of the provided screws
(Figure 3).
Trim
www.dimplex.com