Installation - Dometic CI-21 Manuel D'installation Et D'utilisation

Induction Cooktop

4 Installation


WARNING: ELECTRICAL SHOCK AND/OR
FIRE HAZARD . Failure to obey the following
warnings could result in death or serious
injury .
• This cooktop is provided with a 120 VAC power cord
and must be plugged into a 120 VAC receptacle that
is accessible to the user.
• Do not use the cooktop in narrow spaces. When
using the cooktop, place it horizontally and allow at
least 1 in. (25 mm) of free space between the sides
and back of the cooktop and the wall.
• To avoid overheating, do not cover the ventilation
openings.
• Use a dedicated and high-quality power outlet with
a power rating equal to or above 13.2 A. Do not use
poor quality outlets or share the power outlet with
electrical appliances with high-power ratings, such as
air conditioners, electrical stoves, etc.

WARNING: PROJECTILE HAZARD .
This cooktop must be permanently installed in
the counter top and secured with glue, silicone,
or another secure mounting method. Failure to
secure the cooktop permanently could result in the
cooktop becoming airborne in the occupant space
of the vehicle in the event of an accident. Failure to
obey this warning could result in death or serious
injury.
I Dometic recommends the installation of a
convenience disconnect switch, within 3 ft (0.9 m)
of the induction cooker, that disconnects the 120
VAC power to the cooktop when not in use.
This section describes how to position, assemble, and
install the cooktop.
1. Cut the cooktop and ventilation openings in the
counter top. Refer to "Dimensions and Clearances"
on page 5.
2. Remove any protective film that may still be on the
ceramic plate.
EN
q
5 Fan Cover Connectors on Cooktop Underside
Fan Cover Connectors
q
3. Carefully turn the cooktop upside down.
4. Push the fan cover connectors into the holes next to
the fans until you hear a click.
The connectors are different sizes. If they don't
I
fit in the holes, turn the fan cover 180°.
q q
6 Placing the Cooktop
Cutout
q
5. Apply a continuous bead of glue or silicone to the
sealing strip.
6. Place the cooktop into the cutout.
7. Verify that the air inlet and air vent align with the
corresponding ventilation cutouts.
Installation
w
Sealing Strip
w
7