HP OFFICEJET PRO 8100 Guide De Mise En Route page 9

Set up wireless (802.1 1) communication
Step 2: Test the wireless connection
To test the wireless connection and make sure it is
working properly, complete the following steps:
1. Make sure the printer is turned on and paper is
loaded in the tray.
2. Press (Wireless) button and
simultaneously.
Change the connection type
If you have installed the HP software and connected
your printer using a connection, such as USB or
network connection, you can change to a different
connection any time you want.
Note: If you are changing to a wireless
connection, make sure that an Ethernet cable has
not been connected to the printer. Connecting an
Windows
1. On the printer control panel, press and hold
the (Wireless) button and the
button for three seconds.
2. On the computer desktop, click Start, select
Programs or All Programs, click HP, select
your printer name, and then click Printer
Setup & Software.
3. Follow the display instructions to complete
the setup.
The printer prints a report with the results of the test. If
the test fails, review the report for information on how
to fix the problem and rerun the test.
For additional troubleshooting information, see
"Wireless (802.1 1) setup problems" on page 1 1.
(Resume) button
Ethernet cable turns off the printer's wireless
capabilities. You might be prompted to
temporarily connect a USB cable during the
setup process.
Follow the instructions for your operating system.
Mac OS X
1.
(Cancel)
2.
3.
4.
9 9
On the printer control panel, press and hold
the (Wireless) button and the
button for three seconds.
Open HP Utility. (HP Utility is located in the
Hewlett-Packard folder in the Applications
folder at the top level of the hard disk.)
Click Applications on the toolbar.
Double-click HP Setup Assistant, and then
follow the onscreen instructions.
(Cancel)