Location - Hoshizaki KM-40C-HC Notice D'utilisation

ENGLISH
Remove shipping carton, tape(s) and packing. If packing material is left in the icemaker, it will not work properly.
1) After removing the packaging, make sure that the icemaker is in good condition. If in doubt, please do not use the icemaker
but apply to professionally qualified personnel.
2) Remove the shipping tape holding the door and separator.
3) Remove the protective plastic film from the exterior. If the icemaker is exposed to the sun or to heat, remove the film after the
icemaker cools.
4) Remove the package of accessories. Check the contents according to "2. ACCESSORIES".

4. LOCATION

This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 7°C to 38°C. Normal operating water temperature should be within
7°C to 32°C. Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affect
production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
[KM-40/60/80C-HC(-W)]
Top View
Left
[KM-140C-HC(-W)]
Top View
15 mm
Left
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.
Avoid prolonged exposure of the appliance to direct sunlight.
Rear
15 cm
Right
15 cm
15 cm
ICEMAKER
Front
Rear
15 mm
5 cm
Right
ICEMAKER
Front
NOTICE
WARNING
CAUTION
NOTICE
IMPORTANT
Side View
Front
40 cm
Side View
40 cm
Front
4
Top
15 mm
Rear
15 cm
ICEMAKER
Top
5 cm
15 mm
Rear
ICEMAKER