Instructions For Use - WOLFF LR 690 Manuel

Instructions for use

WARNING !
Before performing any work on the air
purifier, pull out the mains plug.
Before initial operation
Unpack the air purifier and accessories,
and check that no parts are missing or
were damaged during transport.
Place air purifier on a solid, level surface.
Check that all filters are installed in the
product. To check briefly remove the top
cover, then replace it and secure with the tabs.
Installing exhaust air hose
NOTE
Connect exhaust air hose and position is
correctly to ensure that the filtered air is blown
out of the room with the exhaust discharge
outside the renovated area.
Install exhaust flange.
Unscrew screw, push exhaust air hose
onto the flange and tighten the screw on
the clamp.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
Loosen the cords and pull out the
exhaust air hose.
The exhaust discharge should be outside the room!
Installing and replacing filters Pre-filter-fabric G3
Push the front grille slightly upwards (1.)
and remove it forward (2.).
Insert pre-filter fabric G3 in the front
grille (3.).
Push front grille under the rail (4.) and
lower it to lock it (5.).
www.wolff-tools.de
17