Troubleshooting - pullman Ermator T 7500 Manuel D'utilisation

4. Tighten a strap around the Longopac dust bag and
the container to attach the bag correctly to the
container.
5. Pull the Longopac dust bag down on the outer side
of the bag holder.
Troubleshooting schedule
Issue
Motor does not start
Motor stops immediately after
starting
Motor runs but there is not suc-
tion
Motor runs but there is poor suc-
tion
16

Troubleshooting

Cause
No power
Cable defective
Switch defective
Contactor combination defective
Phase error (red lamp lights up)
Wrong fuse
Shortcut in cable/machine
Hose not connected
Hose blocked
No dust collection bag
Hole in hose
Filter clogged
Loose top cover
Dirt in the flap
Defective gaskets
6. Close the bottom of the Longopac dust bag with a
cable tie.
Solution
Plug in machine
Replace cable
Replace switch
Replace contactor combination
Switch 2 phases
Connect to correct fuse
Order service
Connect hose
Clean hose
Fit dust collection system
Replace hose
Clean filter/ Replace filter
Adjust
Clean the flap
Replace affected gaskets
966 - 003 - 11.04.2022