pullman Ermator T 7500 Manuel D'utilisation page 15

3. Rotate the tank forward.
4. Rotate the filter plate anticlockwise 10 degrees and
carefully turn the filter and holder upside down.
5. Put a plastic bag above the filter unit.
6. Lift out the filter carefully in the bag and close it.
The bag must be discarded. Refer to local disposal
regulations.
7. Put on a new complete filter package in reverse
order.
To change the Hepa filter
CAUTION:
trying to clean a Hepa filter will destroy it.
When installing the replacement filter, make
sure to not touch the inside of the filter. Any
kind of force/damage on the inside of filter
media will destroy the new filter..
CAUTION:
surface of the filter when installing a
replacement Hepa filter. Damage to the
inner surface of the filter can make it
unserviceable.
1. Loosen the toggle fasteners on the filter cap and
remove it.
2. Carefully lift the filter into a clean plastic bag.
Note:
This bag must be properly disposed.
3. Insert a new filter in reverse order.
To install a new Longopac dust bag
WARNING:
before you replace the Longopac dust bag.
966 - 003 - 11.04.2022
Do not clean Hepa filter,
Do not to touch the inner
Always clean the prefilter
1. Put the Longopac dust bag in the holder.
2. To attach the Longopac dust bag holder, twist the
Longopac dust bag holder until the pins engage in
the slots.
3. Pull the Longopac bag up from the holder and put it
around the container.
15