Maintenance - pullman Ermator T 7500 Manuel D'utilisation

WARNING:
done by an approved electrician.
If the red lamp (A) between the red and the green button
lights up, there is a phase error. Switch 2 of the phases
to reset (B). This is a safety measure to make sure that
the pump does not start to blow.
A
B
Introduction
WARNING:
equipment, refer to
equipment on page 10 , during service. Dust
can be exposed during maintenance and
service.
WARNING:
machines occur during trouble shooting,
service and maintenance as staff have to
locate themselves within the risk area of the
machine. Prevent accidents by being alert
and by planning and preparing the work.

Maintenance

Look for signs of wear,
damage or loose connec-
tions of the controls before
the unit is connected.
Do a check that the Longo-
pac is correct.
Do a check of the filter
cleaning mechanism.
Do a check of the dust
hose and the connections.
966 - 003 - 11.04.2022
Electrical work must be
180°
Maintenance
Use personal safety
Personal protective
Most accidents involving
Before each Daily
use
X
X
X
X
WARNING:
switched off during operations described in
this chapter unless otherwise stated.
WARNING:
components should only be performed by a
licensed electrician.
Maintenance schedule T-Line Dust
Extractor
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Weekly When suc-
tion is low
The motor should be
All checks involving electric
6 months or 12 months
1000h or 2000h
13