Publicité
Les langues disponibles
Les langues disponibles
Dynamic Wireless Microphone
These instructions are intended for users without
any specific technical knowledge Please read these
instructions carefully prior to operation and keep
them for later reference All operating elements
and connections described can be found on the
fold-out page 3
1
Overview
1.1 Fig. 1: Hand-held microphone
1 Microphone cartridge; to insert batteries, un-
screw the cartridge (figs 2 to 4)
2 LC display; shows the transmission channel
and the charging status of the batteries during
operation
3 Cap for control elements; remove the cap for
operation (fig 5)
4 Power switch
1.2 Figs. 2 to 4: Inserting batteries
(microphone cartridge unscrewed)
5 4-pole contact, on the microphone cartridge
(fig 2) and on the handle (fig 3);
prior to assembling the microphone cartridge
and the handle, connect the contacts
6 Lock for the battery holder (7);
to unlock the holder, press the lock backwards
in arrow direction
7 Battery holder for two 1 5 V batteries of size
AA (R6)
1.3 Fig. 5: Control elements
(cap removed)
8 Key SET
with the unit not locked:
to call up and to exit the adjusting modes
for channel / sensitivity / lock function,
☞
chapters 5 1, 5 2 and 5 3 1
with the unit locked:
to call up and to exit the adjusting mode for
the lock function,
9 Key
for channel selection "down" (in the
channel adjusting mode), to reduce the sensi-
tivity (in the sensitivity adjusting mode) and to
deactivate the lock function (in the lock mode)
10 Key
for channel selection "up" (in the chan-
nel adjusting mode), to increase the sensitiv-
ity (in the sensitivity adjusting mode) and to
activate the lock function (in the lock mode)
All manuals and user guides at all-guides.com
☞
chapter 5 3 2
2
Important Notes
The microphone corresponds to all relevant direc-
tives of the EU and is therefore marked with
•
The microphone is suitable for indoor use only
Protect it against dripping water and splash
water, high air humidity and heat (admissible
ambient temperature range 0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never use
chemicals or water
•
No guarantee claims for the microphone and
no liability for any resulting personal damage or
material damage will be accepted if the micro-
phone is used for other purposes than originally
intended, if it is not correctly operated or if it is
not repaired in an expert way
If the microphone is to be put out of
operation definitively, take it to a local
recycling plant for a disposal which is not
harmful to the environment
3
Applications
In combination with the multifrequency dual re-
ceiver US-902D / 5 from JTS, this dynamic hand-
held microphone with multifrequency transmitter
makes up a wireless audio transmission system
Within the UHF frequency range of 518 – 542 MHz,
the transmission channel can be selected among
16 channels as desired
The microphone is supplied with a stable
transport case, a microphone holder and several
push-on plastic caps of different colours
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare that
the wireless microphone MH-920 / 5 complies with
the directive 2014 / 53 / EU The EU declaration of
conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the fol-
lowing countries:
CZ
DE
IT
LT
In the Federal Republic of Germany, the unit re-
quires a frequency assignment (for which a fee
is charged) In other countries, it is necessary to
apply for a corresponding approval Prior to op-
erating the unit outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country Links to the
EL
FI
FR
MT
PL
7
Publicité
