End Of Charging; Data View Mode - Single Cell Voltage/Internal Resistance - XciteRC X-PERT X90T Mode D'emploi

LiPo BCHG 6S 00:00:45
Input Volt
End Volt.
CAPA Cut-Off
Safety Timer
Temp.Cut-Off
STOP DATA
24.75V 00:01:41 LiPo BCHG 6S 00:00:45
EN
STOP
1) 4.124
2) 4.130
3) 4.113
4) 4.122
5) 4.135
6) 4.117
STOP DATA
Nixx Cycle record
C1 : 9 D1 :
C2 : 0 D2 :
C3 : 0 D3 :
C4 : 0 D4 :
C5 : 0 D5 :
STOP DATA

End of charging

• If the battery is fully charged, FULL appears in the display, as well as an acoustic signal sounds for about
10 seconds.
• NOTE: if the charging process is terminated by safety timer, the display will show STOP. Check the
charging parameters and start the charging process again if necessary.
• When charging is complete, the battery can be disconnected from the charger. If the charger is no longer
needed, it should be disconnected from the power supply.

Data View Mode - single cell voltage/internal resistance

here you can check the single cell voltage and internal resistance of the connected battery pack.
1) 4.110
2) 4.097
3) 4.103
4) 4.105
5) 4.103
6) 4.109
BACK LiPo
1) 08mΩ
2) 15mΩ
3) 06mΩ
4) 09mΩ
5) 14mΩ
6) 04mΩ
BACK LiPo
1) 4.108
2) 4.097
3) 4.103
4) 4.104
5) 4.102
6) 4.108
STOP
28
DATA monitor
Current input voltage
:
12.51V
:
25.20V
Battery cut-off voltage
:
10.0Ah
Max. capacity
:
240min
Safety timer
:
60
℃
Battery cut-off temperature
GRAPH CELL
GRAPH
BACK
graphical display of the
charging voltage
Press BACK to go back to the
charging monitor
GRAPH CELL
CELL
graphical and numerical display
of the cell voltages
GRAPH CELL
NiXX CYCLE
numerical display of the cycle
0mAh
data
0mAh
0mAh (NiXX mode only)
0mAh
0mAh
GRAPH CYCLE
LiPo
IR BALA
VOL BALA VOL
BALA
00.00.09
End of charging · Data View Mode
Select battery type
(LiPo / LiIo / LiFe)
Select single cell voltage
VOL or internal resistance
IR.
The balancer function BALA
is recommended for an
unbalanced or old battery.
Press BALA to start.
X-pert Charger X90T