Charging Process - XciteRC X-PERT X90T Mode D'emploi

Charging process

• Make sure that the charger is connected to the power supply. Connect the battery to be charged as
described in „Connecting the battery" with the charger.
EN
• Set the battery type, number of cells and charging current.
• WARNING: Never charge with incorrectly set cell type. Check the maximum charge current speci-
fied by the battery manufacturer - fire hazard!
BCHG
SET
TYPE CELLS
LiPo
Set Charge
BACK
LiPo BCHG Confirm
-Connect -
Input Vol
Mainport
Bala Port
BACK
LiPo BCHG 3S 00:00:11
Voltage
Current
Capacity
Int Temp.
Ext Temp.
STOP DATA
26
LS> LiPo CHG
6S 2.2A
CHG DCHG
Ω
BATT MISC
CURR
3S 2.2A
Current
2.2 A
SAVE START
... OK
... OK
... OK
START
: 11.99V
:
2.13A
:
3mAh
:
28
℃
:
No sens
GRAPH CELL
Select battery memory by using the
arrow keys
Press charge mode, for example BCHG
CYCLE
To change the settings see chapter
Charging modes.
POWER
Main Menu BCHG
1. Check the charging parameters (see chapter
Charging modes)
2. Start charging bei pressing the START key
3. The charger is checking the battery.
Is everything OK and the battery settings
corresponds with the connected battery,
OK is shown in the display.
4. Start charging bei pressing the START key
again.
Charging monitor
Voltage: current battery voltage
Current: current charging current
Capacity: charging capacity
Int. Temp.: Charger internal temperature
Ext. Temp.: is an external temperature sensor connec-
ted, the temperature is shown hier
Charging process
X-pert Charger X90T