Overview - XciteRC X-PERT X90T Mode D'emploi

Warnings and safety notes · Overview
• WARNING: do not expose batteries / rechargeable batteries to heat or throw into fire - fire or
explosion hazard!
• WARNING: insert batteries / rechargeable batteries with the correct polarity, no short-circuiting -
fire or explosion hazard!
• WARNING: do not use defective or damaged batteries or rechargeable batteries – fire hazard!
Risk of chemical burns on contact with skin, use protective gloves!
• WARNING: Do not attempt to recharge non-rechargeable batteries in a charger - fire or explosion
hazard!
• WARNING: Allow the cells to cool down before charging, never charge hot cells - fire or explosion
hazard!
• WARNING: Remove the batteries from the device before charging. Never recharge batteries that
are permanently installed in a device - fire or explosion hazard!
• Immediately remove used batteries from the devices.
• NOTE: note the specified storage voltage for lithium batteries. Is a completely full or empty lithium
battery time stored for a longer time, it can be damaged.
• NOTE: NiMH batteries must be checked at least every 3 months and, if necessary, recharged, other-
wise because of the typic self-discharge they may get deep discharged and damaged! Therefore, better
use so-called RTU batteries with a very low self-discharge.
The XciteRC Modellbau GmbH & Co. KG cannot monitor the proper use of the battery or batteries you use,
therefore, the warranty is excluded due to incorrect charging or discharging.

Overview

LCD-Touch Display
Output
X-pert Charger X90T
100 - 240 V AC
Fan
Balancer connector
2-6S Lithium XH
11 - 18 V DC
USB socket
5 V / 3A
EN
USB connection
(for Firmware updates
and PC software) -
not used
Servo / PPM output
- +
Temperature sensor
(optional)
21