Charging Process; Charging Mode Lithium Batteries - XciteRC X-PERT X90T Mode D'emploi

Charging process · Charging mode Lithium batteries

Charging process

• Make sure that the charger is connected to the power supply. Connect the battery to be charged as
described in „Connecting the battery" with the charger.
• Set the battery type, number of cells and charging current.
• WARNING: Never charge with incorrectly set cell type. Check the maximum charge current speci-
fied by the battery manufacturer - fire hazard!

Charging mode Lithium batteries

The following types of Lithium batteries can be charged: LiPo - Li-Ion - LiFe
X-pert Charger X90T
Note: the charger will set the charge current
according to a rate of 1C automatically when
you set the capacity of the battery pack. If the
battery pack allows you to charge with a
higher rate, you can set the current CURR
higher.
WARNING: check the battery sticker to
make sure the battery is designed for a
higher charging current - fire hazard!
Menu Settings
You may set the number of cells (CELLS),
capacity (CAPAC), current
end-of-charge/ discharge voltage (ENDV). The
adjustable current ranges from 0.1 - 10.0 A.
In the middle of the display the number of cells the
charger detects is shown. If the number is correct
and suits with your settings, press the START
button. Otherwise correct with CELLS.
Start the charging process by pressing Enter for
more than 2 seconds.
After connecting the battery and press START
once, the charger is checking the battery and
displays OK.
To start the charging process press START, to
stop and check the settings again press BACK.
Press to go back a layer.
Press STOP to go to the charge current menu.
(CURR) and
EN
27