Uas Installation - Safety 1st Alpha Omega 65 Manuel De L'utilisateur

UAS Installation

Safety Tips
Make sure harness and buckle fit your child correctly before
installing the child restraint. See pages 3-4.
Experts agree that children should remain rear facing as long as
possible. In this child restraint, your child can remain rear facing up
to 18 kg (40 lb) and up to 91 cm (36 in.).
WARNINGS:
Do not use the vehicle lap or lap/shoulder
belt when using the Universal Anchorage System (UAS).
Check UAS belt before each use. Use only if the belt can be
tightened properly and securely.
Do not fasten both UAS hooks on the same UAS anchor bar
in the vehicle.
Do not use any recline position except to install the child
restraint fl ush against the vehicle seat back. Vehicle seat
back must be upright.
Failure to follow these warnings can result in serious injury
or death.
Review your vehicle owner's manual for UAS belt use.
1. Remove UAS from
Storage Location
Or if UAS was used rear
facing, pull UAS belt out of
rear-facing belt path so both
hooks are on the same side
of the seat.
41
2. Route UAS Hook
Through Forward Facing
Belt Path
The UAS adjuster can be on either
side.
Do not twist belt.
3. Finished UAS Routing
4. Place Child Restraint
Forward Facing Flush
Against Vehicle Seat
Back
Do not use any recline positions
except to make the child restraint
flush against the vehicle seat back.
Vehicle seat back must be upright.
5. Loosely Attach Tether
Hook
Check vehicle owner's manual for
specific location.
continued on next page
42