Siting; Assembling The Group And Loading The Filter - BWT P-GFI 400 Notice D'installation Et Conseils D'utilisation

2.

SITING

The filtration group must be installed on a flat, level surface and at a distance of at least 3.5 m from the
water (French standard C15-100). The electrical power supply must be protected by 30mA differential
circuit breaker. The filter group should be installed close to a drain or waste line to facilitate evacuation of
backwash water. 1 lid with multiport valve,
3.

ASSEMBLING THE GROUP AND LOADING THE FILTER

1
B
Assemble the base by clipping the 2 tabs on the
pump support plate (A) into the notches on the filter
support plate (B).
3
Screw in the drain plug.
16/48
2021/01 - Indice de révision : H - Code : 26660
A
Position the pump on its support plate using 2
screws, washers and nuts.
Lower the filter onto its base, taking care to posi-
tion the drain plug in the cut-out provided for this
purpose.
2
4
Drain plug
Cut-out
FILTRATION