BWT P-GFI 400 Notice D'installation Et Conseils D'utilisation page 17

5
Unscrew and remove the ring.
7
Gluing the unions onto the lid: The transparent
union is joined to the waste outlet, the black union
to the inlet and the 3 piece union to the outlet on the
'pump' side.
Caution: avoid using excess glue, this could
damage the ball in the valve.
9
Carefully pour the sand into the filter and, using your
hand, spread it out evenly.
FILTRATION
6
Remove the lid/valve assembly (positioned upside-
down during transport).
8
Check that the collector plate is correctly positioned
at the bottom of the filter tank. Insert the collector
pipe (topped with its cap) into the hole in the middle
of the collector plate.
Quantity of sand
Sand grain size
2021/01 - Indice de révision : H - Code : 26660
MGi 400 MGi 500
20 Kg 50 Kg
0.6/1.25
17/48