Instructions For Proper Use - Sunrise Medical Jay Dermafloat LAL 1000 Serie Instructions D'utilisation

INSTRUCTIONS FOR PROPER USE

(Numbers in parentheses refer to Mattress and Bed Diagrams on page 9.)
1. Remove mattress from bed frame (1).
2. Replace mattress with the Jay LAL 1100 Series Standard Low Air
Loss (2) or Homecare Low Air Loss Mattress. Make sure to orient
mattress so the air tubing (3) exits the mattress at the foot of the bed.
3. Loop each of the four black nylon straps (4) to the bed frame and secure
with the D-Rings provided.
4. Suspend control unit from the footboard using the two hooks located on
the back of the unit as shown (5). If no footboard exists, place unit on a
flat surface near the foot end of the bed. (Be careful not to position the
unit on the floor in such a manner that it may become a hazard to foot
traffic.)
5. Connect the free end of the tubing (3) to the respective mating connector
located on the side of the pump (6). This "quick connect" fitting can be
secured by simply mating the two ends together in a linear but opposing
direction.
Mattress must be attached to the mattress manifold. Simply join the
tube onto the clear tube receptacle.
6. Check that the hose is secure by gently pulling. Ensure the air hose is
not kinked or tucked under the mattress.
7. Cover Jay LAL 1100 Series Standard Low Air Loss Mattress with
the Therapeutic Low-Shear comforter and attach to the mattress D-rings
provided. (Verify comforter is loosely fitting so as not to "hammock"
patient above the mattress. If comforter appears tight verify ICU size
sheet is not covering a standard sized mattress).
8. Carefully plug power cord into a properly grounded outlet. Unit will
enter "STANDBY" mode when dial is set to 0. Settings greater than 1
will automatically initiate the blower operation.
The connector tube for the Homecare Low Air Loss
7