ITW SIMCO ION LB - UNIT Notice D'utilisation page 29

Warning:
 When carrying out work on the equipment: de-energise the equipment.
1. Remove the lid from the power unit.
2. Remove the required seal(s) (blind gland).
3. Fit the gland (of the equipment to be connected) into the box.
4. Connect the HV cable(s) to the terminal block.
5. Mount the lid onto the box.

Make sure that:
 HV cable(s) are not looped inside the box.
c
orrect
Important:
 When connecting non-metal shielded HV cables, the HV cables connected to the
various transformers may not be crossed and must be laid at least 1 cm apart. Non-
compliance with this rule will have negative influences on the HV cables.
LB-Unit_UM_9752083410_NL_D_GB_F_V2_0
incorrect
28