EN
Product contents and product overview
Before fi rst use
Any water residue in the cleaner tank is due to the fact that
the product was tested after assembly and is not a defect.
•
Unpack all parts and remove all protective foils and stickers.
Check the product contents for any damages from transport.
Should you identify any transport damages, do not use the pro-
duct (!), instead please promptly consult the customer service.
•
Assemble the mop by fi rst inserting the upper pole (3) into the
bottom pole (4) until it audibly locks into place and then in-
sert the upper pole (3) into the pole receptacle on the cleaning
head (8) until it audibly locks into place. Your mop is now ready
for use!
Use
ATTENTION!
■
When cleaning laminate fl oors, make sure that you do not
spray too much liquid cleaner on the fl oor. Otherwise it could
cause it to swell up!
1. Open the cleaner tank (5) by screwing its lid off.
2. Fill the cleaner tank (5) with water or a cleaner of your choice.
3. Screw the lid back onto the cleaner tank (5).
4. Insert the cleaner tank (5) into the receptacle on the spray
head (6).
5. Affi x the cleaning cloth to the cleaning head (8) with the hook-
and-loop fastener.
6. Now mop your fl oors as usual by moving the cleaning head (8)
across the area you wish to clean and pressing the spray trig-
ger (2) as needed to dampen the fl oor using the spray noz-
zle (7).
7. Fill the cleaner tank (5) if it is empty and, if necessary, wash the
cleaning cloth out with hot water in between.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
1 Handle
1
2 Spray trigger
2
3 Upper pole
4 Lower pole
5 Cleaner tank (approx.
600 ml)
6 Spray head
3
7 Spray nozzle
8 Cleaning head with
cleaning cloth
4
5
6
7
8
Customer Service / Importer:
All rights reserved.
Cleaning and storage
ATTENTION!
■
Do not use any scouring or abrasive cleaners or cleaning pads
for cleaning.
■
Only air dry the cleaning cloth; do not in any case machine dry
it or dry it with a hair dryer!
•
Clean the mop with a damp cloth and mild cleaner as needed.
•
You can wash the cleaning cloth in the washing machine. Do
not use any softener as it may reduce the suction power
of the cleaning cloth! Make sure you follow the instruc-
tions on the cleaning cloth's washing label. Then let the
cleaning cloth air dry.
Disposal
The packaging material is recyclable. Dispose of the pack-
aging in an environmentally-friendly manner and make it
available to the collection service for recyclable materials.
Dispose of the product in an environmentally-friendly man-
ner, too. For more information, contact the administrative
body in your community.
✆
+49 38851 314650 *)
Instructions
Z 08004 M DS V1 0417