Boosterfunctie For Room-Controlled Heating; Remain Settings; Pin Code; Setting The Desired Hot-Water Temperature - REMEHA Celcia 20 Notice Technique

9 BOOSTER FUNCTION FOR ROOM-CONTROLLED HEATING
A booster function allows for accelerated heating up,
following in increase of the set temperature. Should this
lead to problems (skyrocketing temperature levels), the
booster function may be shut off. The booster function is
activated at delivery.
Set the rotary knob on MENU
Go to the SETTINGS option and press OK
Go to the CONTROLLER option and press OK
10

REMAIN SETTINGS

10.1 Pin code

To change the room temperature setpoint with a
(mobile) telephone, you need, apart from the Celcia
Gateway, a special code. This code has 4 digits:
Set the rotary knob on MENU
Go to the SETTINGS option and press OK
Go to the MISCELLENEOUS option and press OK
Go to PIN CODE and press OK
Set the required value and select OK
Return the rotary knob to the desired programme
and close the lid.

10.2 Setting the desired hot-water temperature

With Celcia 20 you can set the hot-water temperature
of the combi-boiler or hot-water storage heater
temperature has priority over the temperature setting in
the boiler. Change the temperature as follows:
Set the rotary knob on MENU
Go to SETTINGS and press OK
Select CONTOLLER and press OK
Go to DHW TEMP
Set the required value and select OK
Return the rotary knob to the desired programme
and close the lid.
only if a sensor is fitted
*)

10.3 Maximum pre-heating time

The "automatic pre-heating" function ensures that the
room is at the required temperature at the programmed
moment. So in cold periods the boiler will start heating
earlier than in warm periods. Celcia 20 automatically
calculates how much earlier the boiler has to start
heating. The "Maximum pre-heating time" setting can
be used to limit this time or deactivate the function
completely (in that case, set the value at 0). Note: If you
do so, it may not be warm on time.
Set the rotary knob on MENU
Go to SETTINGS and press OK
Select CONTROLLER and press OK
Go to PRE HEAT and press OK
Set the required time and select OK
Return the rotary knob to the desired programme
and close the lid.
Go to CONTROL and press OK
Select WEATH COMPENS and press OK
Go with the OK-button to BOOSTER
Select YES or NO and select OK
Select now ROOM CONTROL and press OK to
return to room-controlled heating
Return the rotary knob to the desired programme
and close the lid.

10.4 Legionella

To prevent Legionella growth, it is good to warm up a
calorifier once a week. The Legionella function in Celcia
20 warms up a calorifier every Monday between 0:00
and 03:00 to 65°C. This functions only when a calorifier
sensor is mounted and not with a thermostat.
To switch on/off
Set the rotary knob on MENU
Go to SETTINGS and press OK
Select CONTROLLER and press OK
Go to LEGIONEL and press OK
Select YES or NO and press OK
Return the rotary knob to the desired programme
. This and close the lid.
*)

10.5 Counters reset

Resetting the Celcia Gateway hor counters and boiler
starts can be achieved by entering the PIN-code 0012
(see par.10.1). Then turn Celcia 20 rotary knob to
"MENU" and push " info-button i repeatedly until the
function "RST COUN NO/YES" appears. Confirm with
OK.
Don't forget to reset the de PIN-code to the set value.
13