Maximum Pre-Heating Time - REMEHA CELCIA 20 Manuel D'utilisation

I I _ _ V V A A L L U U E E
5 Enter the in the same way.
6 Return the rotary knob to the desired pro-
gramme and close the lid.
Fig. 14 Set control parameters
5.7 Select display variation
The DISPLAY setting allows you to choose which information
the display should contain.
The display has 2 lines for this purpose, namely the text line T
and the numerical line N. You can choose from 5 variations,
see table below.
Rotary knob position Rotary knob position
Display variation Display variation
1 2 3 4 5 1
Time T T N
Pre-set temp. N N T
Measured temp. N N T N
Progr. Name T
I I _ _ V V A A L L U U E E 1 Set the rotary knob on MENU.
MENU
2 Go to S S E E T T T T I I N N G G S S
3 Select M M I I S S C C E E L L L L A A N N E E O O U U S S
4 Go to D D I I S S P P L L A A Y Y
5 Set the required mode and select OK.
6 Return the rotary knob to the desired pro-
gramme and close the lid.

5.8 Maximum pre-heating time

The automatic pre-heating function ensures that the room
other
is at the required temperature at the programmed moment. So
2 3 4 5
in cold periods the boiler will start heating sooner than in
N
warm periods.
N N
N
T T T T
Celcia 20 calculates itself how much earlier the boiler has to
start heating. The detailed installer's guide describes how to
change this function.
39
and press OK.
S S E E T T T T I I N N G G S S
and press OK.
M M I I S S C C E E L L L L A A N N E E O O U U S S
and press OK.
D D I I S S P P L L A A Y Y M M O O D D E E
ENGLISH