IARP EXTRA SLIM COOL EMOTION Instructions Pour L'utilisateur page 19

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
18. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate
pre-established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
1. Unlock the electronic controller by hold down "SET" button for 5 sec. (on the display the word "UNLOCK" will
appear).
1. Press the (SET) key in order to see on display the temperature set point.
2. Press the (▲) key or the (▼) key in order to increment or decrement the temperature set point.
3. Press the (SET) key in order to store the new temperature set point.
LIGHT SWITCH
(Short pressure)
19. MALFUNCTION AND REMEDIES
Most of the functioning inconveniences are generally due to defective electrical connections.
These problems can usually be solved on the place.
Check that the unit is properly plugged
Check that the unit is properly plugged
Check that the plug cord is broken
If power failure is not due to any of the above causes, call the nearest after-sales service immediately, empty the cabinet and store the foods
in coldrooms or refrigerators that may ensure their preservation temperature.
Check door is perfectly closed
Make sure that the cabinet has been filled correctly
Check that the unit is not adjacent to sources of heat
Check that behind the cabinet air can properly circulate.
Check the temperature setting
Check that there is not too much ice on the evaporating shelves
If failure to cool should is not due to any of the above reasons it it persists on even after the above checks, resort to the nearest after-sales service.
Check that all the bolts and nuts are properly fastened
Check that the unit is placed on an even surface
Check if any pipe or fan is in contact with any other part of the body
Should the inconvenience persist, contact the nearest after-sales service.
EXTRA SLIM COOL EMOTION
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
THE UNIT DOES NOT START
CAUSE
THE INTERNAL TEMPERATURE IS NOT COLD ENOUGH
CAUSE
THE UNIT IS NOISY
CAUSE
SOLUTION
Insert the plug
Insert the plug correctly
Replace the plug cable
SOLUTION
Close correctly
Load the product correctly
Position the equipment correctly
Position the equipment correctly
Set the correct temperature
Defrost the equipment
SOLUTION
Screw in the screws
Position the equipment correctly
Switch off the counter and distance the parts
in contact in the event the problem persists,
contact the support service.
2 0 / 5 2
PAGE
UM000300
N° DOC
AUTHORISED STAFF
User
User
Technical support
AUTHORISED STAFF
User
User
User
Technical support
User
User
AUTHORISED STAFF
User
User
Technical support