IARP EXTRA SLIM COOL EMOTION Instructions Pour L'utilisateur page 18

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
15. OUTER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER PLUG
BEFORE CLEANING.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
1. EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral soap and
water solution.
2. STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry with soft cloth.
Avoid scouring pads etc. which will spoil the finish of the stainless steel.
3. SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and dry with soft
cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
4. GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable to use
ordinary water which can leave a film of calcium on the surface of the glass.
16. INNER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER PLUG
BEFORE CLEANING.
If , however, the layer of frost on tank walls exceeds 4/5 mm in thickness, you should completely defreeze the
appliance as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature
2. Leave the doors open and begin the operation of tank washing when the tank temperature is the same as the
ambient temperature.
3. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and fresh water.
4. Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
5. Avoid water entering into the appliance lighting units.
6. Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process, other
than those recommended by the manufacturer.
17. MAINTENANCE
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention on the
flammable refrigerants.
WARNING! Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
ATTENTION! Use protective shoes and gloves during maintenance operations.
OPERATION
Cleaning the outer surface
Cleaning the accessible inner parts
Checking the power supply, electrical plugs and/or sockets
Seals intactness check
Check the acceptable condition of warning plates
Fridge system tubing intactness check
Inspecting the cables and inner power connections
Replacing the led lights
Replacing the power supply cable
Control panel replacement (electronic control unit)
Any other maintenance operation not planned in the previous points should be carried out by the
support centres authorised by our dealers or by qualified staff.
EXTRA SLIM COOL EMOTION
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
(do not use tools)
ORDINARY /
FREQUENCY EXTRAORDINARY
MAINTENANCE
Based on use Ordinary
Based on use Ordinary
Six-monthly Ordinary
Six-monthly Ordinary
Six-monthly Ordinary
Six-monthly Ordinary
Six-monthly Ordinary
- Extraordinary
- Extraordinary
- Extraordinary
1 9 / 5 2
PAGE
UM000300
N° DOC
AUTHORISED
STAFF
User
User
User
User
User
Technical support
Technical support
Technical support
Technical support
Technical support