Table Des Matières; Introduction; Unpacking; Preparation For Use - Leica DM E Mode D'emploi

Leica DM E
Instruction Manual
Contents
1.0 Introduction .................................................................2
2.0 Unpacking .................................................................2
3.0 Preparation For Use 3.1 Viewing Body.................................2
3.2 Installing Objectives ......................3
3.3 Substage Condenser.....................3
3.4 Filters ..............................................3
4.0 Operation
5.0 Care of Microscope 5.1 General...........................................4
5.2 Mechanical Maintenance ............4
5.3 Lamp Replacement........................4
5.4 Electrical Considerations/
5.5 Fuse Replacement.........................5
Explanation of Warning Symbols
CAUTION: Replace with same type and rating fuse:
5x20mm, 3.15 Amp/250V, Quick acting (# 13WFAG30001)
CAUTION: Risk of
electric shock
.........................................................3
Equipment Ratings.........................5
CAUTION: (Refer to accom-
panying documents)

1.0 Introduction

Thank you for purchasing the DM E from Leica Microsystems. The
Leica DM E Compound Microscope combines exclusive design fea-
tures and a full range of accessories making it a truly versatile, qua-
lity instrument for advanced academic and routine clinical applica-
tions.
CAUTION: This instrument should only be used as described.
Hazards may result if used improperly.

2.0 Unpacking

Carefully remove the microscope components from the packing car-
ton. Check the components against the following standard equipment
list:
1. Stand: includes focusing
mechanism, graduated
mechanical stage,
nosepiece and integral
illumination system.

2. Viewing Body

3. Objectives
4. Eyepiece(s)
Optional items such as contrast accessories, camera adapters
and systems, multiviewing systems and carrying cases are not
shipped as part of the standard equipment. These items are
delivered in separate packages.
Please do not discard any of the packing materials. They should
be used for safely storing and transporting the instrument
should the need arise.

3.0 Preparation for Use

3.1 Viewing Body
Attach the viewing body to the stand by backing off the set screw on
top of the stand with the tool provided. Then insert the dovetail of the
viewing body into the stand support and tighten the set screw firmly
without forcing it. This precisely locates the body on the optical axis
of the microscope, regardless of the selected orientation. After the
body is attached, insert the eyepieces into the eyetubes. Attach the
power cord and turn on the DM E using the knurled dial on the lower
left side. Note the dial will be illuminated.
5. Condenser
6. Immersion Oil
7. Spare Lamp
8. Dust Cover
9. Power Cord
10. Blue Filter
11. 3mm Allen Wrench
English
2