Mount The Camera Ir Reflection Shield - Leica DMil Mode D'emploi

7. Assembling the Options
• Camera position should face upright, if not will
cause the image has certain angle. Loosen the
ring on the camera to adjust the position of
camera, and tight the ring afterwards
Note:
The port on the rear side of the stand is for power
supply for the camera, not for data transmission
purpose.
The infrared signal receptor of camera is on
the back side of the stand. If the camera is con-
nected with a monitor, the monitor needs to put
at least 10 cm beside Microscope, to allow the
space for infrared signal to pass through.

7.3 Mount the camera IR reflection shield

The camera shield is an IR reflection shield for
the camera remote control.
• Place the IR reflection shield left or right in the
back of the instrument in an angle of 45°.
• Insert the quick start guide of camera or a
white paper into the IR reflection shield
Fig. 19 Rear view of the stand
1 Camera USB power supply port (PWR port)
2 Integrated C-Mount
28
Fig. 20
Fig. 21
1 Camera
2 Camera protection shield
Fig. 22
1 IR reflection shield
2
1
Camera mount
Rear view of the stand
Mounting camera IR reflection shield
1
45°
2
1