Facom W.410WB Notice D'instructions page 7

MAINTENANCE
1. Lubricate the axes and moving parts at regular intervals (E).
2. The elements of the press should be kept clean and protected from aggressive conditions at all times.
3. Always use original spare parts.
4. Check the oil level of the pump with the piston of the cylinder fully retracted and refi ll as required in accordance with the
volume indicated in the table.
reach the tank. The cover is threaded on its upper part.
5. IMPORTANT: An excess of oil may affect the operation of the hydraulic unit.
6. Only use hydraulic oil,
3 at 50ºC.
EXTREMELY IMPORTANT: Never use brake fl uid.
7. A frequent inspection should examine:
• Wear on the piston, cylinder, pump, accessories or incorrect connections.
• Oil leaks, signs of corrosion.
• Damage to the structure, accessories, table and supports, lost screws or plug-ins.
TO CHANGE THE MANOMETER
Remove the metal cover, position the manometer, making sure that the O-ring seal which is inside
the manometer casing remains at the bottom upon installation. Secure the manometer according to
the fi gure (H), without applying excessive force.
REPAIR
1. Both the maintenance and repair of these presses should be carried out by qualifi ed personnel, who as a result of their
training and experience are familiar with the hydraulic systems used.
2. Both the repair kit, which exclusively contains the o-rings and seals of the jack, and the spare parts sets must be
orderedusing the reference assigned in the table.
3. TO PURGE THE HYDRAULIC CIRCUIT:
- Open the release valve by turning it to the left.
- As follows, pump the hydraulic unit several times.
- Lastly, close the release valve by turning it completely to the right.
PROBLEM
1. The piston does not lift
2. Piston does not lift totally
3. Piston lifts very slowly
4. Cylinder looses pressure while holding the load
5. Oil leakage
6. Piston does not retract fully
GUARANTEE
Type D = 2 years. See the general conditions in the FACOM catalogue or the FACOM price list.
Subject to compliance with all of the above instructions.
NU-W.410 415WB 430BO 450MA 430ML 450PN_0615.indd 7
To perform this operation, you must fi rst release the side cover of the press that allows us to
WA.22 type, with an ISO grade of cinematic viscosity of 30cSt at 40ºC or of an Engler viscosity of
CAUSE
Release Valve is opened
Air in hydraulic circuit
Low oil level
Dirt in hydraulic circuit
Non-correct hydraulic connection
Deformed piston
Low oil level
Deformed piston
Air in the hydraulic circuit
Dirt in hydraulic circuit
Air in th
draulic circuit
Dirt in hydraulic circuit
Worn or damaged seals
Worn or damaged seals
Non correct hydraulic connection
Excess of oil
Deformed piston
Dirt in hydraulic circuit
Damaged return spring
Release valve closed
H
SOLUTION
Close release valve
Purge the circuit
Refi ll with required volume
Clean hydraulic circuit
Assure hydraulic connection is correct
Contact your distributor
Refi ll
Contact your distributor
Purge hydraulic circuit
Clean hydraulic circuit
Purge the hydraulic circuit
Clean hydraulic circuit
Contact your distributor
Contact your distributor
Assure hydraulic connection is correct
Remove excess of oil
Contact your distributor
Clean hydraulic circuit
Contact your distributor
Open the release valve
Bar
Turn
Don't turn
7
10/1/2015 10:45:57 AM