Control Panel - ESAB ESP-600C Manuel D'instruction

sectIon 4

4.2 control panel

J
4.2 Control Panel
K
WARNING
!
I h
A - Main Power
Indicator illuminates when input power is applied to the power source.
B - Contactor On
Indicator illuminates when the main contactor is energized.
C - Over Temp
Indicator illuminates when power source has overheated.
D - Fault
Indicator illuminates when there are abnormalities in the cutting process or
when the input line voltage falls outside of the required nominal value by
±10%.
E - Power Reset Fault
Indicator illuminates when a serious fault is detected. Input power must be
disconnected for at least 5 seconds and then reapplied.
F - Current Dial (Potentiometer)
ESP-600C dial shown. ESP-600C has a range of 50 to 600 A. Used only in
panel mode.
116
f
ESP-600C Plasma Power Source ESP-600C Plasma Power Source ESP-600C Plasma Power Source ESP-600C Plasma Power Source
Covers Removed.
High voltage compon
operatIon
increasing shock haz
Internal component m
because cooling fans
g
a
c
B
D
e
Main Power Main Power
Main Power Main Power
Indicator illuminates when
the power source.
Over Temp Over Temp Over Temp Over Temp
Indicator illuminates when
overheated.
Contactor On Contactor On
Contactor On Contactor On
Indicator illuminates when
energized.