Installation; General; Unpacking; Placement - ESAB ESP-600C Manuel D'instruction

sectIon 3

3.1 general

WarnIng

3.2 unpacking

cautIon cautIon
• Inspect for transit damage immediately upon receipt.
• Remove all components from shipping container and check for loose parts in container.
• Inspect louvers for air obstructions.

3.3 placement

• A minimum of 1 M (3 ft.) clearance on front and back for cooling air flow.
• Plan for top panel and side panels having to be removed for maintenance, cleaning and inspection.
• Locate the ESP-600C relatively close to a properly fused electrical power supply.
• Keep area beneath power source clear for cooling air flow.
• Environment should be relatively free of dust, fumes and excessive heat. These factors will affect cool-
ing efficiency.
cautIon
faIlure to folloW InstructIons coulD leaD to Death, InJurY
or DaMageD propertY. folloW these InstructIons to pre-
vent InJurY or propertY DaMage. You Must coMplY WIth lo-
cal, state anD natIonal electrIcal anD safetY coDes.
using one lifting eye will damage sheet metal and frame.
use both lifting eyes when transporting with overhead method.
Use both lifting eyes when transporting from overhead.
conductive dust and dirt inside power source may cause arc flash-
over.
equipment damage may occur. electrical shorting may occur if dust is
allowed to build-up inside power source. see maintenance section.
note:
103

InstallatIon