Control Panel - ESAB EPP-400 Manuel D'instructions

sectIon 4

4.2 control panel

j
k
l
h
I
A - Main Power
Indicator illuminates when input power is applied to the power source.
B - Contactor On
Indicator illuminates when the main contactor is energized.
C - Over Temp
Indicator illuminates when power source has overheated.
D - Fault
Indicator illuminates when there are abnormalities in the cutting process or
when the input line voltage falls outside of the required nominal value by
±10%.
E - Power Reset Fault
Indicator illuminates when a serious fault is detected. Input power must be
disconnected for at least 5 seconds and then reapplied.
F - Current Dial (Potentiometer)
EPP-400 dial shown. EPP-400 has a range of 12 to 600 A. Used only in panel
mode.
108
f
operatIon
g
a
c
B
D
e