La Marzocco linea Mode D'emploi page 14

1) Installation on the counter
The image below shows the recommended method to drill the hole on the counter.
OF MACHINE
HERE THE POSITION OF THE
POWER CORD
140 mm
5,5 in.
290 mm
11,5 in.
HERE THE POSITION
OF THE DRAIN TUBE
630 mm - 24,8 in. (4 groups)
195 mm - 7,7 in. (1, 2 and 3 groups)
13
FROM ∅100 TO ∅120 mm
FROM ∅4 in. TO ∅4,7 in.
CENTER
170 mm
6,7 in.
65 mm
2,5 in.
Fig. 5 - Hole on the Counter
2) Water test kit
In order to enable you to check if your water
supply is within the suggested ranges, La
Marzocco machines will be equipped with
two units of a quick water test kit (see image
below) including 6 test-strips and instruction
HERE THE POSITION WHERE WE
cards.
SUGGEST TO MAKE THE HOLE
ON THE TABLE
The
that
measure
Total
WATER INLET HOSES
Total Iron, Free
Chlorine,
Chlorine, pH &
Total
60 mm
Chlorides.
2,4 in.
Ideally,
should
150 mm
a test on the
6 in.
water BEFORE the water treatment system
and again AFTER the water system in order
to verify if this is actually matching our
suggested ranges.
Once the test has been performed, learn
which treatment system is most appropriate
for your particular water supply by filling out
the online water calculator on our website: LA
MARZOCCO WATER CALCULATOR (http://
www.lamarzocco.com/water_calculator/).
parameters
you can
are
Hardness,
Total
Alkalinity,
you
perform