Faber Inca Lux 21 SS Instructions D'installation page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
The Hood can be installed directly on the underside of the wall unit
(Minimum 24" - 30" from the Cooking Surface).
Create an opening in the bottom of the wall unit, as shown.
nectors.
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
as shown.
place.
Vf
underneath the hood.
Open the filter cover panel by turning the specific knob.
Disconnect the panel from the hood canopy by sliding the fixing
fixing pin lever.
pin levers.
Remove grease filters
and set aside.
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
Screw the Frame into place using the 6 screws 12f, recon-
nect the wires to the Connector and the Electrical ground
cable (Yellow/Green) removed previously. Replace the metal
grease filter and the Panel.
EN
8
INSTALLATION
Fitting the Hood canopy
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED A
Fitting the Hood canopy
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
Insert the hood until the side supports snap into place.
Fasten using the 10 screws 12a provided.
• Create an opening in the bottom of the wall unit,
Lock in position by tightening the screws Vf from underneath the hood.
as shown.
• Insert the hood until the side supports snap into
place.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws Vf from
underneath the hood.
• Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 screws 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
7
Fitting the Hood canopy
7 7
7 7
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Inca lux 28 ssInlx21ss600-bInlx28ss600-b

Table des Matières