Snap-On EEWB330B Mode D'emploi page 36

L'équilibreuse de roues par ordinateur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

E22
Speed low
The rotation speed of the wheel has not reached the
minimum limit needed to enable balancing.
Check that the brake (pedal) or wheel is not
accidentally blocked.
Check that something is not braking or ob-
structing the wheel.
Check the power supply.
Fit the wheel correctly.
Contact
Technical Support at 800-225-5786.
E24
Velocity fl uctuations
If the speed of the wheel to keep to the need to com-
pensate.
• Check that the wheel is not obstructed or impeded
by something.
• Check the power supply.
• Fit the wheel properly.
• Call
Technical Support at
E25
Reverse error.
The shaft is rotating at a certain speed but in the
wrong direction.
Apply the brake.
Contact
Technical Support at
The display clears when rotation stops.
E26
No acceleration.
No shaft acceleration has been registered.
Contact
Technical Support at 800-225-5786
36
800-225-5786.
800-225-5786.
E27
Slipping registered.
The wheel slips on the shaft.
Fit the wheel correctly.
E28
Speed limit reached.
Contact
E50
Manufacturer's calibration incomplete
Contact
E51
Calibration failed
Switch unit off, wait for 20 seconds.
Switch unit on.
Retry calibration, or:
Contact
E52
The calibration weight is on the opposite side to the
calibration carried out by the manufacturer.
Fit the User Calibration Weight correctly on
the left side of the fl ange. Repeat Calibration.
Contact
E82
Fault during self-test at start-up.
Switch unit off, wait for 20 seconds.
Switch unit on.
E92
During the second attempt the SAPE Arm for distance
and rim diameter was still not in the home position.
Both SAPE Arms are rendered inoperative.
Wait 5 seconds, or press the STOP key to
continue.
EEWB330B
Technical Support at
800-225-5786.
Technical Support at
800-225-5786.
Technical Support at 800-225-5786
Technical Support at 800-225-5786

Publicité

Table des Matières
loading

Table des Matières