Snap-On EEWB330B Mode D'emploi page 27

1
2
3
4
5-32
5-34
5-37
A
5-38
Reading OP.8 appears
•
If balancing optimization (silent running) has been
carried out correctly (according to the program cycle),
after the check run the machine automatically returns to
the type of weight positioning previously selected and
indicates the residual dynamic imbalance on the wheel.
•
Both optimization and balancing are accomplished.
5
Message E9
Message E9 means that at least one error occurred
during the optimization cycle. Press the STOP key
to exit the optimization program and repeat optimization
if necessary.
Option 2: Do not turn the tire over on the rim
•
The result is recalculated.
Reading
•
Option 3: Abort optimization
•
The imbalance on the wheel is shown on the readout.
•
Reading
Readjust the tire on the rim (the right display bars light
up permanently).
Option 1: Readjust the tire on the rim
(normal program)
•
•
•
B
•
•
Reading OP.8 appears
•
5-39
EEWB330B
(Fig.
Spin the wheel (START).
Balance the wheel according to the readings.
Press the FINE key (3).
OP.7 - II or H0 or H2 appears
II - OP.7
To go to (turning over the tire) press the
FINE key (3) again.
Press the STOP key (5) to exit the OP program and
return to the balancing program.
Balance the wheel according to the readings.
OP.7 - II (Fig. 5-37)
Readjust the wheel following the right direction
indicator and make a double mark on the right side
of the tire exactly perpendicular to and above the
main shaft (Fig. 5-38).
Remove the wheel from the machine
Readjust the tire on the rim until the double mark
coincides with the valve
Clamp the wheel on the balancer and readjust so
that the valve is exactly perpendicular to and above
the main shaft.
Press the ENTER key
position.
(Fig.
Spin the wheel (START) (check run).
5-34).
(Fig. 5-39).
(1) to acquire the valve
5-34).
(5)
27