Snap-On EEWB330B Mode D'emploi page 29

1
2
3
4
5-32
5-35
5-34
5-36
5-37
Weight minimization program cycle
If the rim compensation run was omitted and the
key (3) was pressed to go directly into the minimization
program (reading Un.), proceed as follows.
Clamp the wheel.
•
Position the valve exactly perpendicular to and
•
above the main shaft.
Press the ENTER key (1) to acquire the valve
•
position.
Reading Un.4 appears
5
Spin the wheel (START).
•
The measuring run is carried out. After the measuring
run two readings are possible:
Un.5 - H1
Further minimization is not recommended, but is possible.
Un.5 – I (1 Reference mark
Continue with the UN program.
Reading Un.5 - H1
If Un.5 - H1 appears, further minimization is not
recommended since the measurement values do not
exceed the limit values. However, it is possible to
continue minimization so as to achieve an improvement,
if only slight (e.g.: for critical vehicles).
To continue minimization:
Proceed as indicated for reading Un.5 – I.
•
To abort minimization:
Press the STOP key (5) to return to the balancing
•
program and balance the wheel according to the
readings.
Reading Un.5 – I (1 Reference mark
After the measuring run readjust the wheel according
•
to the direction indicator and make a chalk mark
(Fig. 5-36)
perpendicular to and above the main shaft.
Readjust the tire on the rim so that the mark
•
coincides with the valve (use the tire changer
5-37).
Clamp the wheel on the balancer and readjust it so
•
that the valve is exactly perpendicular to and above
the main shaft.
Press the ENTER key (1) to acquire the valve
•
position.
Reading Un.6 appears
Spin the wheel (START).
•
The machine performs the second measuring run
with the tire. After the measuring run three readings
are possible:
II - Un.7
Proceed with the UN program. It is recommended that
the tire be turned over on the rim.
EEWB330B
(Fig. 5-34).
Fig. 5-35)
Fig.
on the right side of the tire exactly
(Fig. 5-34).
FINE
5-35)
Fig.
29