Snap-On EEWB330B Mode D'emploi page 31

1
2
3
4
5-32
Reading
Readjust tire on the rim (the right display bars light up
permanently).
Option 1: Readjust the tire on the rim
(normal program)
Readjust the wheel according to the right direction
•
indicator and make a double mark on the right side
of the tire exactly perpendicular to and above the
main shaft
Remove the wheel from the machine.
•
Readjust the tire on the rim until the double mark
•
coincides with the valve
5
Clamp the wheel on the balancer and readjust it so
•
that the valve is exactly perpendicular to and above
the main shaft.
Press the
•
position.
Reading Un.8 appears
Spin the wheel (START) (check run).
•
If weight minimization was carried out correctly
(according to the program cycle), the machine
automatically returns to the type of weight positioning
previously selected and indicates the residual dynamic
imbalance on the wheel.
Balance the wheel according to the readings.
•
Both weight minimization and balancing are
accomplished.
Message E9
Message E9 means that at least one error occurred
during the minimization cycle. Press the STOP key (5) to
exit the minimization program and repeat minimization
if necessary.
Option 2: Do not readjust the tire on the rim
Press the STOP key (5) to exit the minimization
•
program and return to the balancing program
The imbalance on the wheel is shown on the readout.
Balance the wheel according to the readings.
•
Reading H0
The optimum minimization condition has been achieved
and cannot be improved.
Press the STOP key (5) to return to the balancing
•
program and continue according to the readings.
EEWB330B
Un.7 - II (Fig. 5-37)
(Fig. 5-38).
(Fig.
ENTER key (1) to acquire the valve
(Fig. 5-34).
5-39).
31