Starting The Machine; Stopping The Machine; Using The Machine; Warnings - Berkel BM +32T Mode D'emploi Et D'entretien

machine.
5.3 - Checking the efficiency of the stop pushbutton (fig. 5.3.1)
While the machine is connected to the
power supply and the tool is moving, press
the stop pushbutton "2" Fig. 5.3.1. The
machine must stop.
5.4 - Starting the machine (fig. 5.3.1)
To start the machine just press the start pushbutton "1" Fig. 5.3.1 after having
correctly connected the plug to the electrical outlet and the machine will start.
5.5 - Stopping the machine (fig. 5.3.1)
To stop the machine just press the stop pushbutton "2" Fig. 5.3.1 and the machine
will stop.

6 - Using the machine

6.1 - Warnings

ATTENTION!
Only authorized personnel can operate the machine.
Before using the machine, the operator must make sure that all the protections are
in place and that the safety devices are fitted and efficient. If not, turn off the
machine and notify the head of maintenance. The product to be ground must be in
pieces that can enter the loading mouth and they must be pushed with the help of
a proper pushing utensil (pestle) NEVER DO THIS WITH YOUR HANDS.
6.2 - Setting up the outlet or the proper pushing device (pestle).
The machine can be set up in three different meat-
cutting groups:
A - Enterprise or normal
B - Half UNGER
C - Total UNGER
-
System -C-, (total UNGER), consists of : a propeller
"1" to transport the meat, a hammer mill plate "2", a
first blade "3" and corresponding perforated plate
"4", a second blade "5" with the final perforated
plate "6".
-
System -B-, (half UNGER), substitutes the blade "5"
and the plate "6" with the spacer "7".
-
System -A-, (Normal), is the simplest method in that it is only
composed of a transport propeller, a blade and an outlet plate.
It is not possible to assemble the plates from groups -C- or -B– on models with the
grinding group -A-, instead the complete group must be changed.
1 2
15
Fig. 5.3.1
3
Fig. 6.2.1