Safety Protections And Devices; Work Position - Berkel BM +32T Mode D'emploi Et D'entretien

1.8 - Safety protections and devices

ATTENTION!
Before using the machine make sure the devices are correctly positioned and in
perfect condition. At the beginning of each work shift check that they are fitted and
working efficiently; if not, notify the head of maintenance.
3
5
1
Fig. 1.8.1
3. The stainless steel hopper is firmly blocked at the loading mouth.
4. Protection carters for electrical components.
The lower part of the machine is closed by a carter, blocking involuntary access
to electrical components inside of it.
5. Micros on the hopper.
A magnet corresponding to the safety sensor is assembled in the lower part of
the hopper.
ATTENTION!
Do not tamper with the safety devices in any way or for any reason.

1.9 - Work position

The correct work position for the operator to optimize working with the machine is
indicated in fig. 1.9.1.
1. Product outlet, with plate holes smaller than 8
2
mm. In this case introducing fingers into the
mouth is impeded. Upon request an outlet plate
with holes having a diameter greater than
8 mm can be installed. In these cases the user
will be responsible for the installation of a
proper protection on the mouth.
2. Hand guard.
The hopper has the protection "2" Fig.1.8.1
page 13, in compliance with the circular from
the Ministry of Work and Social Security n° 66
4
dated 05/09/79.
9
Fig. 1.9.1